Universal Ford 9" Rear Disc Brake Upgrade Kit for Pre-1980 Models

The F111 provides an easy to install, bolt on solution for upgrading your pre-1980 Ford passenger car 9" rear-end to disc brake performance. Our kit is unique in that it provides all the brackets and flanges that fit the three most popular sizes of the small bearing 9" rear ends. and also check out your axle flange measurements, it should be 6 1/8" in diameter or smaller.
   
When you install your kit you will have the brackets and spaces for all three of the small bearing 9" rear ends. Each set has been individually bagged for ease of identification. The easiest way to identify which set you will use is to check the holes in the spacer plate (in bags labeled A, B, and C) to see if they align with the holes in your axle housing.

Axle flange patterns:

3-3/8 x 2 ( 8" rear axle, Small bearing)
3-1/2 x 2-3/8  ( 9 " rear axle,  large bearing)
3-9/16 x 2   ( New ford 9" or Torino flange)

Kit includes

•     Vented Rotors (11.5'' O.D. with 2.8'' Hub I.D.)

•     Drilled for Ford 5 x 4.5'' w/ 1/2'' studs ( 2 bolt patters, Ford and GM)

•     5 x 4.75'' w/ 7/16'' stud bolt patterns

•     Calipers have the emergency brake built in for added safety

•     10 MM Rubber Hoses & Banjo Bolts with Copper Crush Washers 

•      E-brake kit and cable to replace factory cables

•     hardware ( bolts, tube spacers, clips and all necessary shims)

  
  

  We offer the necessary options so you can match the front kits...... 

• colors and cross drilled rotors.